Lixel L2 Pro
Advanced real-time 3D reconstruction device with minimal post-processing workflow, featuring AI-enhanced SLAM and dense point cloud generation.
Latest
Firmware V3.2.3
For Lixel L2 Pro
File Size1.1 GB
Released2026.10.28
Release Notes
- Release Notes
- 1. Bug fixed
Important
Notes：
1. When using scanner firmware v3.2.1 with LixelGO v1.3.0, historical model viewing is supported and Flash Connect mode is enabled by default.
- Scanner firmware v3.2.1 with LixelGO versions below v1.3.0 supports Flash Connect mode only.
- Scanner firmware below v3.2.1 with LixelGO v1.3.0 does not support historical model viewing.
2. Please back up all data on the device before upgrading the firmware.
Version History 4
V3.2.12026.01.261.0 GB
- 1. The device now switches to Quick Connect mode by default.
- 2. Updated the USB storage mode logic: the device automatically switches to USB storage mode when connected to a computer.
- 3. Added support for generating historical model preview files after scanning is completed.
- 4. Added support for Points of Interest (POI).
- 5. Added a data availability check feature.
- 6. Optimized camera ISP parameters, resulting in more vivid and vibrant colors.
- 7. Fixed an issue causing Bluetooth connection timeouts.
- 8. Fixed several other bugs.
V3.1.12025.08.271.1 GB
- 1. Support mobile app forwarding RTK base station data to the scanner (quick-connect mode), while still enabling the scanner RTK to obtain a fixed solution.
- 2. Support real-time output of point cloud data with absolute coordinates.
- 3. Support automatically stopping real-time mapping and switching to log-only mode when memory usage exceeds 90%.
- 4. Fixed the issue where RTK base station offset caused map offset (known affected regions: New Zealand, Australia).
- 5. Fixed an issue where abnormal battery level readings caused device malfunction.
- 6. Fixed a potential crash when stopping scanning.
- 7. Fixed an issue where PPK data could not be read in PPK mode.
- 8. Mitigated the issue of memory growth caused by latency.
V3.0.22025.06.251.2 GB
- 1. Adopted a new data format (xbin), reducing file size to approximately 20% of the original.
- 2. Updated the scanner-APP communication protocol; must be used with LixelGO version 1.2.0.
- 3. Supports setting the device's country location, and automatically configures local Wi-Fi frequency bands based on the selected country.
- 4. Added GNSS modes, supporting PPK, RTK, and DJI.
- 5. Supports remote device control via LixelStudio 3.3.1.0.
- 6. Added "Quick Connect" mode; note that remote device control, RTK connection, and device activation are not supported in this mode.
- 7. Fixed an occasional issue where no fixed RTK solution was obtained after connecting RTK.
- 8. Fixed an issue where RTK CORS connection failed via iOS wired connection.
- 9. Fixed an RTK timestamp offset issue.
- 10. Device no longer distinguishes between LCC mode and Point Cloud mode.
- 11. Fixed an issue where scanning would automatically stop under certain conditions.
V2.4.12025.01.161.1 GB
- 1. Fixed the issue of image brightness being too low in low-light conditions.
- 2. Resolved the incorrect point count in point cloud data saved from 32-channel LiDAR.
- 3. Fixed the RTK OTA upgrade failure issue.
- 4. Added a feature for custom project naming.
- 5. Corrected inaccurate timestamps in LiDAR point cloud data.